So I’m building a new computer before the end of the year and lemmy is obviously pushing me towards Linux.

I am not computer savvy, I have a family member that will help me set up my PC, but I do not want to be calling/messaging them every day when I want to open a program.

Basically my question comes down to: can I operate a Linux PC these days without needing to troubleshoot or type code.

I use my computer about once a week for a few hours I would say, so any time spent troubleshooting is time wasted.

Thanks!

EDIT: since a lot of people are asking what programs I typically use, I’ll just list my most used programs.

Word, Excel, ect(I’m fine with alternatives)

Spotify

Gimp (would have been a make or break, so I’m glad it’s supported)

Brave browser (browser is a browser)

Steam

Discord

I would say that while I could figure out how the kernels work, I’m at a point with computers these days where I don’t have the time. My priorities fall with a seamless daily experience. If I have the time to figure something out I can, but ideally my day to day usage being unbotherd is what I’m after.

A lot of the comments so far have been helpful! I’m definitely going to give Linux a fair shot with my new build, probably start with Mint.

  • bastion@feddit.nl
    2·
    2 months ago

    Yes, it’s easy. BUT:

    • buy Linux-compatible hardware. While you might technically be able to get something to run by fucking around, it’s just better to bit Linux-compatible hardware. If something doesn’t work, it doesn’t work, put it on a shelf and try again in six months.
    • If you’re dual-booting windows, know that windows occasionally nukes the boot loader, so that only windows loads. This happens irregularly, like every 2-5 years. A Linux friend can help fix it, or you can follow instructions online (you need an empty thumb drive to do it).
    • Resol van Lemmy@lemmy.worldEnglish
      2·
      2 months ago

      Sometimes, when dual booting Windows and Linux, especially on the same drive, the Windows installation just breaks. Sends you to automatic repair only for it to not work.

      I learned this the hard way.