• 3 Posts
  • 13 Comments
Joined 1 year ago
cake
Cake day: July 7th, 2023

help-circle
  • I actually tried this as my second step in trouble shooting, the first being using different ports.

    In the non-omada management software, it defaults to 10G, and if the devices is on before the switch it negotiates 10G correctly and works at full speed (tested with iperf3). As soon as any of the 10G connected devices is rebooted, I’m back to 1G. To fix it, I then have to set the port to 1G with flow control on, apply changes, save config, refresh page, change to 10G with flow control off, apply, save config and it goes back to 10G again. Alternatively I can reboot their switch and it’s fine again.

    In Omada its the same, fewer steps to get there but I have to sometimes do it 2-3 times before it works.

    Same issue with both 10G TP-Link switches, so I’m thinking it might be the SFP. Using Intel SFP+ with FS optical cables. I’m using a DAC for the uplink from the 10G switch to my unmanaged 2.5G switch, and that doesn’t have the problem of dropping, always works max speed.







  • Thanks for the detailed reply.

    So the command gives me an error that nfs-client cannot be found.

    The fstab just has basic default config. No timeout set.

    I considered network issues, though it seems to be quite stable for other services. Not ruling it out just yet. I have a new switch coming in the next week, so will test if the issue persists when I put that in.

    I will also give autofs a shot.

    Thanks!









  • Very cool piece of software. I played around with it a few weeks back with some scanned slides and it gave good results. Some of the models were better for general objects and background while other models were better for people.

    The only issue was (and I admittedly didn’t spend any time to try and resolve it), that I couldn’t open the output photos outside of the app. I could see the result in the app, but opening the file directly gave an error.