I did like one semester of computer science, does that count?
Honestly I just google shit until I understand it. Linux has great documention, and where it fails you can just read the source code.
I did like one semester of computer science, does that count?
Honestly I just google shit until I understand it. Linux has great documention, and where it fails you can just read the source code.
The flip side to this, is that the vast majority of meat in pet foods is effectively waste from human-grade meats, for the same reason. That means the price point for competition in pet foods is significantly lower.
It also means that there won’t be as direct of an impact on livestock numbers should pet food be sourced via synthetic meats, as it just means the byproducts which would enter the food chain for dogs instead become waste products with a cost of disposal.
Holy FPTP, that represenation is fucked. How hoes 33% of the popular vote translate to 60% of parliamentary seats?
Y’all need electoral reform.
smartmontools has some good functionality for interfacing with SMART via usb bridges that do not provide native functionality.
1.2l water
240ml sodium sulfate
60ml sodium chloride
20ml xantham gum(optional for increased efficacy by keeping the solution homogenous)
Boil water, stir until fully dissolved, a small amount of solute should remain, if not, increase sodium sulfate concentration slowly until it does, indicating no free water molecules available for dissolution.
Solution should now be cooled to below 18c( freezing point) for an end product that will regulate temperature to 18c so long as it have sufficient(negative) thermal energy.
Solution of pure sodium chloride will have freezing point approx -20C, while solution of pure sodium sulfate has freezing point +35C. Adjusting the ratio of NaCl to Na2SO4 will shift the freezing point towards either end of thag spectrum, depending on what phase change temperature you are targetting.
This is actually how I do things when working on remote machines. I have far too many monitors, so dedicating on of them to a handful of btop/nvtop terminals works pretty well.
I admit that it’s a less than perfect setup though, and a single program which could handle the remote connections internally and display an aggregate would be nice.
Personally, I have ditched kvms and physical machines in favour of virtual machines everywhere. One set of input devices, three monitors, seamless control of each machine.
It is a very popular Single Board Computer, with a lot of community support that allows people to build and program a variety of things for a low price. Think of it like lego, but for things which can be useful as well as fun.
Want to run a weather station? Pi and a couple of off the shelf sensors, done.
Want to control your lights or appliances from your phone without getting out of bed? Pi and a couple of off the shelf relays, done.
Want to build a retro gaming console? Pi, a couple of off the shelf controllers and some pre-made emulators, done.
I would argue that the modern smartphone is different, but by no means better. Between the locked down operating systems and the lack of a physical keyboard they are great for consuming media through approved channels, but basically useless if you want to get any work done with them.
If it helps, 80% of the work i do when wearing my sysadmin hat is just ensuring that all of our systems are communicating properly.